1957 chev 2 dr wagon project original paint disc front brakes

1957 Chev 2dr wagon 210 model. Very complete car with all seats, body panels glass etc. front of car has new 2 inch drop spindles, new lower and upper ball joints, new tubular control arms, new tie rod ends, new wheel bearings and seals, new calipers, rotors, and soft brake lines, new just installed side mount engine mounts, gas tank was removed cleaned resealed and a new float was installed as well, new rubber overflow line, new rubber gas hose connection, new rear ebrake cable, new rear soft brake lines, new rear brakes, new rear drums, rear end was cleaned and repainted, new gear oil installed. rear axle springs have all new bushings, rear end has a 2 inch drop spacers installed with new u bolts, interior floor was por 15ed as well. just installed new retractors for the rear hatch cables. car is fairly solid was parked in 1971. was built and bought new in canada and spent its whole life down south. original paint as well. floor is very solid driver side front is a bit softer but not bad at all. comes with original front and rear seats as well as the hood as well. the body is solid except in front of rear tires needs some work hard to find these 2 dr wagons in this shape. only selling as i found 2 cars i want . if they sell before this does than i will keep it and continue working on it. lots of money and work spent on it already. the front clip is just sitting on there for now. plans were to put in a small block 350 with a auto trans. but i do have them so they come with the car as well. yes i have the hood and yes i also have the bullets for it as well. located in spruce grove. mags not included will come with tires on stock rollers for it to roll